POWERED BELT INCLINE/FLATTENER CONVEYORS

(MUST SPECIFY ELEVATION FROM FLOOR TO TOP OF BELT AT INFEED AND DISCHARGE END) 

The following specification is what is shown on the photos.  Other configurations are available on request. 

SPECIFICATIONS 

Total Length                   13’- 0”

Infeed Height                  3’- 0”

Discharge Height           4’- 0”

Belt Type                         22" Wide, 2 Ply, 150 lbs/in, Polyester Rough Top

Belt Take-Up                  Center Take-Up on Upper Boom and Lower Conveyor

Belt Support                    2 1/2” O.D. x 11 GA Rollers w/11/16” Hex Shaft on 12” Centers

Roller Bearings              11/16" Hex Bore - Sealed for Life  

Pulley Type                     6” O.D. Seamless Crowned Tubing w/ 1 1/4” CRS Shaft

Conveyor Frame            6" x 8.2 lb. Structural Channel

Frame Width                   27-3/8” B.F.

Floor Supports                6" x 8.2 lb. Structural Channel w/Floor Pads

Motor                               1 HP T.E.F.C. Right Angle Gearmotor, Upper & Lower

Belt Speed                     100 FPM

Boom Adjustment          Hydraulic Hand Pump to Adjust Opening & Pressure

Electrical                         NEMA 12  460 Volt - 3 Phase - 60 Hertz

Controls                           By Others or Can Be Provided

Specials                          Safety Pull Cords and Switches

Paint                                Primer and Finish Coat of Enamel Paint